INSTALLER GUIDE
UNO-TS2 Overview
UNO-TS2 Overview for Installers
Note: The following minimum firmware revisions are required for use with the UNO-TS2:
CAV6.6 Rev. 3 2.01.16 or higher
CAV6.6 Rev. 4 3.01.10 or higher
CAM6.6 1.01.05 or higher
CAM Internal AM/FM Tuner 1.01.01 or higher
CAM Internal XM Module 2.00.05 or higher
ST2 Dual Tuner 3.00.10 or higher
ST2-XM (ST2 Chassis) 3.00.10 or higher
ST2-XM (XM Module) 2.00.05 or higher
ST2S Tuner (Sirius) 1.00.10 or higher
SMS3 Media Server 2.00.07 or higher
17
The UNO-TS2 is an RNET-system enabled touch-
screen that functions similarly to the UNO-S2
keypad. It fits into a double-gang 32ci low volt-
age PVC junction box, uses a CAT-5 110 punch-
down connection, and supports one external IR
receiver. Active system status icons appear on
the screen (shared, master, party and do not dis-
turb). An “All On” or “All Off” can be performed
by pressing and holding the power button.
Controller Configurations
For One UNO-TS2 per Controller
An RNET controller (CAV6.6, CAM6.6) can
support ONE UNO-TS2 touchscreen AND
up to five UNO keypads per controller,
connected directly to the controller via the UNO
System Keypad Ports.
For 2 to 6 UNO-TS2s per Controller
(One UNO-TS2 per Zone)
After the first UNO-TS2, any additional
UNO-TS2s must be connected to the con-
troller via an SA-ZX3 Keypad Splitter. The SA-ZX3
is powered by a 1 amp 1201A power supply with
an RJ45 CAT-5 patch cable to connect to the
controller’s UNO Keypad Port. UNO-S1/S2 key-
pads can share the SA-ZX3 with an UNO-TS2, but
they must be configured for the same zone.
After sources are configured in the RNET sys-
tem, they must be set up in the UNO-TS2 using a
simple onscreen process under Installers Setup.
The configured source names (up to 6 sources)
appear on the UNO-TS2 main screen, and unas-
signed source buttons remain blank. Standard
source names are assigned through the
CAV6.6/CAM6.6. PC Power Tool programming is
needed for any custom naming of sources,
including “iPod.”
The UNO-TS2 uses pre-configured source tem-
plates. Due to the unique source screens, the
UNO-TS2 does not support the key mapping fea-
tures of the UNO-S1/S2 keypads. Custom key
configuration (Key Configuration menu of con-
troller) is not recommended and may result in
unexpected behavior by the UNO-TS2.
The UNO-TS2 may require future updates for
screens and for firmware. These updates are
performed in a similar fashion as UNO-S2
updates, with a programming cable
(P/N 2500-121036) and a PC.
(48 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern